TM 5-3810-305-23
0101
REMOVAL - Continued
5.
Remove 10 differential mounting bolts (Figure 1, Item 6) and washers securing differential assembly
(Figure 1, Item 7) to axle housing.
NOTE
A tap with a soft-faced mallet may be required to break seal between differential assembly
and axle housing.
6.
Apply pressure to hoist and lift differential assembly (Figure 1, Item 7) from axle housing approximately
1 inch (25 mm). Rotate differential 90 degrees to align ring gear with clearance cutouts in axle housing and
remove from housing.
CAUTION
DO NOT interchange bearings, pinions, or input yoke from other axles. Preload is factory set.
Failure to follow this caution may result in damage to equipment.
7.
Remove pinion nut (Figure 1, Item 1), input yoke (Figure 1, Item 2), and dust shield (Figure 1, Item 8).
Discard pinion nut.
8.
Remove trunnion (Figure 1, Item 4) and spacer (Figure 1, Item 3), if necessary.
9.
Remove input yoke seal (Figure 1, Item 5).
1
2
3
8
4
7
5
6
M0315105
Figure 1.
Rear Differential Assembly Removal.
END OF TASK
03/15/2011Rel(1.8)root(maintwp)wpno(M00111)