TM 5-3810-305-23
0106
INSPECTION
Inspect parts IAW General Maintenance Instructions (WP 0162).
END OF TASK
INSTALLATION
1.
Install bracket (Figure 3, Item 11), four capscrews (Figure 3, Item 5), new lockwashers (Figure 3, Item 6), and
nuts (Figure 3, Item 7).
2.
Install capscrew (Figure 3, Item 15) and nut (Figure 3, Item 13) to bracket (Figure 3, Item 12).
3.
Install bumper (Figure 3, Item 18) and screw (Figure 3, Item 4) to capscrew (Figure 3, Item 15).
4.
Position bracket (Figure 3, Item 12) on bracket (Figure 3, Item 11).
5.
Install four new lockwashers (Figure 3, Item 16) and capscrews (Figure 3, Item 17) through bracket
(Figure 3, Item 11) into booster valve (Figure 3, Item 9).
6.
Heat rubber pedal (Figure 3, Item 14) in hot water and install on pedal (Figure 3, Item 2).
7.
Install bushing (Figure 3, Item 1), if removed.
8.
Position pedal (Figure 3, Item 2) against bracket (Figure 3, Item 11).
9.
Apply a coat of petroleum jelly on bolt (Figure 3, Item 3).
10.
Install shoulder bolt (Figure 3, Item 3), washer (Figure 3, Item 21), bushing (Figure 3, Item 20) to new locknut
(Figure 3, Item 19) and install.
11.
Position booster valve clevis to pedal (Figure 3, Item 2).
12.
Install pin (Figure 3, Item 8) and new cotter pin (Figure 3, Item 10) in booster valve (Figure 3, Item 9).
1
2
3
4
5
21
20
19
6
18
7
17
8
16
15
9
11 10
12
13
14
M0499105
Figure 3.
Brake Pedal and Linkage Installation.
03/15/2011Rel(1.8)root(maintwp)wpno(M00118)
