TM 5-3810-305-23
0125
ASSEMBLY - Continued
29.
Check all capscrews and fittings to make certain they have been tightened correctly.
30.
Refill winch assembly with lubricating oil.
31.
Install o-ring (Figure 30, Item 2) and oil level plug (Figure 30, Item 1) on winch (Figure 30, Item 3).
1,2
3
M0677105
Figure 30.
Oil Fill Assembly.
END OF TASK
INSTALLATION
WARNING
Weight of winch is approximately 300 lb (136 kg). Use adequate lifting equipment to lift and
support winch. DO NOT lift over personnel or let personnel walk underneath suspended load.
Failure to follow this warning may cause injury or death to personnel.
1.
Attach hoist and sling to winch base (Figure 31, Item 4) and install on vehicle.
2.
Install four capscrews (Figure 31, Item 1) washers (Figure 31, Item 2) and new locknuts
(Figure 31, Item 3) to secure winch base (Figure 31, Item 4).
3.
Install two elbows (Figure 31, Item 6) on brake valve assembly (Figure 31, Item 7).
4.
Connect two hydraulic hoses (Figure 31, Item 5) to brake valve assembly (Figure 31, Item 7).
5.
Close dipstick cap.
03/15/2011Rel(1.8)root(maintwp)wpno(M00141)
