TM 5-3810-306-20
TURN SIGNAL LIGHT REPLACEMENT
TOOLS: General mechanic’s tool kit: automotive (5180-00-177-7033)
SUPPLIES:
Lockwashers (Item 15, Appendix C) (2 Required)
EQUIPMENT CONDITION:
Disconnect ground cable at shunt. (Refer to page 8-109.)
REMOVAL:
NOTE
Front turn signal shown. Use this for
replacing front and rear turn signal
assemblies.
1.
REMOVE TURN SIGNAL LIGHT (1).
a.
Tag and disconnect electrical leads to turn signal
(1). Remove from wire clip (4).
b.
Remove two capscrews (2), lockwashers (3)
and wire clip (4) from mounting bracket. Discard
lockwashers (3).
INSTALLATION:
1.
INSTALL TURN SIGNAL LIGHT (1).
a.
Align turn signal (1) holes with mounting bracket.
Align wire clip (4) and secure turn signal with two
new lockwashers (3) and capscrews (2).
b.
Remove tags and connect electrical leads to turn
signal (1).
c.
Route wires through wire clip (4).
2.
CONNECT GROUND CABLE AT SHUNT. (REFER
TO PAGE 8-109.)
3.
TEST TURN SIGNALS FOR PROPER
OPERATION. (REFER TO TM 5-3810-306-10.)
END OF TASK
8-45
