TM 5-3810-306-20
DCA PRESSURE DIFFERENTIAL TRANSDUCER
TOOLS: General mechanic’s tool kit: automotive (5180-00-177-7033)
SUPPLIES:
Lockwashers (Item 2, Appendix C) (2 Required)
EQUIPMENT CONDITIONS: Right engine access door open.
Engine cool to touch.
Disconnect ground cable at shunt. (Refer to page 8-109.)
REMOVAL:
1.
REMOVE PRESSURE TRANSDUCER (1).
a.
Tag and disconnect electrical connector(s) to
pressure transducer (1).
b.
Remove hoses (2) and (3) connected to
pressure transducer (1). Cap hoses.
c.
Remove
two
nuts
(4),
lockwashers
(5),
flatwashers (6) and pressure transducer (1).
Discard lockwashers (5).
d.
Remove elbows (7).
INSTALLATION:
1.
INSTALL PRESSURE TRANSDUCER (1).
a.
Install elbows (7) in pressure transducer (1).
b.
Install pressure transducer and secure with two
flatwashers (6), new lockwashers (5) and nuts
(4).
c.
Remove caps and install hoses (2) and (3) to
pressure transducer (1).
d.
Remove tag and connect electrical connector(s)
to pressure transducer (1).
2.
CONNECT GROUND CABLE AT SHUNT. (REFER
TO PAGE 8-109.)
3.
START
ENGINE.
CHECK
FOR
PROPER
OPERATION
OF
AFFECTED
COMPONENT.
(REFER TO TM 5-3810-306-10.)
END OF TASK
8-57
