REAR WHEELS NOT CENTERED SWITCH

ELEVATION SWING WARNING SWITCH INSTALLATION

TM-5-3810-306-20 Container Crane 40-Ton Rough Terrain Model RTB75CC Manual
Page Navigation
213

TM 5-3810-306-20 REAR WHEELS NOT CENTERED SWITCH TOOLS: General mechanic’s tool kit: automotive (5180-00-177-7033) SUPPLIES: Lockwashers (Item 15, Appendix C) (2 Required) EQUIPMENT CONDITIONS: Disconnect ground cable at shunt. (Refer to page 8-109.) REMOVAL: 1. REMOVE REAR WHEELS NOT CENTERED SWITCH (1). a. Tag and disconnect electrical wires to switch (1) NOTE Note number of threads exposed below nut (2) for initial setting of switch (1) on installation b. Remove bottom nut (2) and switch (1) fl)m mounting bracket (6). c. If necessary, remove nuts (3), lockwashers (4), flat washers (5) and mounting bracket (6). Discard lockwashers (4). INSTALLATION: 1.INSTALL REAR WHEELS NOT CENTERED SWITCH (!). a. If removed, install mounting bracket (6) with flatwashers (5), new lockwashers (4) and nuts (3). b. Install switch (1) in mounting bracket (6) with nuts (2). Adjust nuts (2) to expose same number of threads noted on removal. 2. CONNECT GROUND CABLE AT SHUNT. (REFER TO PAGE 8-109.) 3. START ENGINE AND CHECK FOR PROPER OPERATION OF SWITCH (1). (REFER TO TM 5- 3810-306-10.) 4. ADJUST AND TIGHTEN NUTS (2) AS NECFSSARY END OF TASK 8-59

Privacy Statement
Press Release
Contact