TM 5-3810-306-20
g. Remove heater (1).
h. Remove gaskets (8) and replace as required.
INSTALLATION:
1.
INSTALL CAB HEATER/DEFROSTER ASSEMBLY.
a. Install gaskets (8) on heater.
b. Remove plug and align heater (1) over holes in
cab floor mounting plate. Install fuel line (7) and
tighten clamp (9).
c. Tighten two screws (4) to secure heater (1) to
cab floor.
d. Connect air flow tubing (6) to heater (1) and
tighten clamp (5).
e. Insert four multi-pin connectors from heater (1)
to controller wiring harness (3).
f.
Connect controller wiring harness (3) to the
heater (1). Tighten screw (2).
g. Turn fuel on at petcock.
2.
CONNECT GROUND CABLE AT SHUNT. (REFER
TO PAGE 8-109.)
3.
CHECK
CAB
HEATER
FOR
PROPER
OPERATION. (REFER TO TM 5-3810-30610.)
4.
INSTALL SEAT AND PEDESTAL. (REFER TO
PAGE 15-27.)
END OF TASK
15-35
