TM 5-3810-306-20
Section V. ACCESSORY MAINTENANCE
CIRCULATING FAN REPLACEMENT
TOOLS:
General mechanic’s tool kit: automotive (5180-00-177-7033)
SUPPLIES:
Lockwasher (Item 7, Appendix C)
EQUIPMENT CONDITION:
Disconnect ground cable at shunt. (Refer to page 8-109.)
REMOVAL:
1.
REMOVE CIRCULATING FAN (1).
NOTE
Rear fan shown. Use this procedure
for replacing front fan.
a. Tag and disconnect electrical lead.
b. Support fan (1) and remove three machine
screws (2) and lockwashers (3). Remove fan
(1). Discard lockwashers (3).
INSTALLATION:
1.
INSTALL CIRCULATING FAN (1).
a. Align fan (1) with mounting holes and secure
with three machine screws (2) and new
lockwashers (3).
b. Remove tag and connect electrical lead.
2.
CONNECT GROUND CABLE AT SHUNT. (REFER
TO PAGE 8-109.) 3. CHECK FAN OPERATION.
(REFER TO TM 5-3810-306-10.)
END OF TASK
15-30
