TM 5-3810-306-20STEERING WHEEL REMOVALTOOLS:General mechanic’s tool kit: automotive (5180-00-177-7033)SUPPLIES:NoneEQUIPMENT CONDITIONS: Disconnect ground cable at shunt. (Refer to page 8-109.)REMOVAL:1.REMOVE STEERING WHEEL.a. Remove rubber horn cover (1) from center ofsteering wheel.b. Disconnect horn plate (2) by applying pressuredownward, turning at same time.c. Remove metal cup (3), spring (4) and horncontactor (5).d. Remove three screws (6) and remove horncontactor plate (7) by sliding horn contact wirethrough hole in contactor plate (7).WARNINGDo not attempt to pull off steeringwheel (5) without using steeringwheel puller. Excessive pulling mayresult in sudden loosening and causepersonal injury.NOTENote position of steering wheel for reassembly.e. Remove nut (8) and use puller to remove wheel(9) from shaft.INSTALLATION:1.INSTALL STEERING WHEEL.a. Install steering wheel (9) on shaft and securewith nut (8).b. Install contactor plate (7) in steering wheeland secure with screws (6). Install horncontactor (5), spring (4) and metal cup (3).d. Install horn plate (2) by applying slight pressureand turning to engage tab into contactor plate.e. Press on rubber horn cover (1).2.CONNECT GROUND CABLE AT SHUNT. (REFERTO PAGE 8-109.)3.CHECK HORN OPERATION. (REFER TO TM 5-3810-306-10.)END OF TASK15-40
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
