TM 5-3810-307-10
During the programming procedure the Load Moment Prewarning Light (3) and the Load
Moment Limit Light (2) will light up and the aggravating crane movements will be
interrupted.
NOTE
If a configuration is selected which is not available, the display will indicate
error code E04. In this case, the procedure has to be repeated with valid
values.
WARNING
The correct setting is of utmost importance for the proper functioning of the
system and the crane. Therefore, only operators who are thoroughly familiar
with the crane and the operation of the system should execute the setting of
the system according to the operating configuration of the crane.
The LMI programming procedure consists of the following steps:
NOTE
The main boom and counter weight configuration are automatically setup.
This system is not set up for use with an extension or additional counter
weight.
setting the hoist configuration
setting the outrigger configuration
setting the reevings
confirmation of the programming procedure
For easy operation, the computer guides the operator through the procedure step by step
(interactive operation).
Definition of the Displayed Symbols:
The following illustrations define the symbols appearing on the display during the setup
procedure. Not all symbols will be shown, depending on the crane type and the answers to
the questions.
Setting the hoist configuration
Front Hoist
Rear Hoist
Change 1 G-15