TM 5-3810-307-10
If, during the crane operation, the crane is switched over from front to rear hoist, the LMI
system has to be adjusted to this modification. This modification can be entered without
having to go through the whole LMI setup procedure again:
Call LMI setup procedure.
Directly call function "Hoist Line Selection".
NOTE
The direct call is not possible, if the
system has been turned off for more
than two hours.
Select hoist:
Front Hoist
Rear Hoist
Confirm modification.
(call up the function again if you have selected
the wrong hoist by mistake)
NOTE
If a configuration is selected which is not available on the crane, the system
will not accept the selection and the display will indicate the error code E04.
Change 1 G-19
