SM02-027-0
Change-1 Page 15
5.
The use of two aligning studs will facilitate
aligning the converter housing to the transmission
housing. Install the converter housing to the trans-
mission using extreme caution to align the clutch
pilots into the clutch disc hubs. As the clutch pilots
enter the disc hubs, turn the turbine shaft and output
shaft back and forth. This will help align all the the
clutch inner discs with the disc hubs. DO NOT FORCE
THIS OPERATION.
6.
When all the clutches are properly aligned, the
converter housing will be tight against the transmis-
sion housing. Install two housing to housing cap-
screws and lockwashers. Tighten the capscrews to
the proper torque specified. Refer to SM02-025-0,
TRANSMISSION/TORQUE CONVERTER for the ap-
plicable torque chart.
8.
Position the oil baffle in the housing and install
the retaining ring. Ensure the ring is in full position in
the ring groove.
7.
Apply a light coat of Permatex #2 to the outer
diameter of the oil baffle seal. Press the seal into the
baffle with the lip of the seal toward the impeller hub
CAUTION
bearing. Position a new oil baffle sealing ring onto the
oil baffle.
Use extreme caution as not to cut, break,
or unhook the oil sealing ring on the
support.
9.
Install the impeller and hub assembly using
caution as not to damage the oil baffle seal.