SM08-015-1
Page 14
NOTE
Steps 17 thru 20 apply to multiple sec-
tion pumps only.
15. Slide the driven gear through the housing and into
the bushing in the shaft end cover. Coat the steel sleeve
tool with grease. Place the lightly greased drive shaft in-
side the sleeve and slide both through the shaft end
cover with a twisting motion until the integral gear rests
17. Position the bearing carrier over the gear housing
against the thrust plate. Avoid damaging the double lip
so that the bushings receive the joumals of the drive and
seal. Remove the steel sleeve. Squirt clean oil over the
driven gears. Ensure the dowel holes are lined up over
the dowel pins. When the parts are parallel, squeeze
them together or alternately tap over each dowel until
the parts are together.
16. Slip the thrust plate with the seal over the gear jour-
nals and into the housing bore. The flat side of the seal
18. Insert the connecting shaft in the spline of the drive
should face up with the relief groove facing the outlet
gear. Position and place the second gear housing on the
side.
bearing carrier as outlined in step 12.
