SM08-015-1
Page 12
9. Before inserting a new lip seal in the shaft end
cover, coat the outer edge of the lip seal and it's recess
7.
Repeat steps 11 and 2, stone and rinse all parts.
with Permatex Aviation Form-A-Gasket No. 3 non-
hardening sealant or equivalent. With the metal side of
the lip seal up, press it into the mounting flange side of
the shaft end cover with an arbor press and bar. Be care-
ful not to damage the lip of the seal. Press it in until it is
flush with the recess and wipe off any sealant.
8. Ensure all dowel pins are in place in any new cast-
ings. Examine all dowels. Refer to WEAR LIMITS. Be-
fore inserting, ensure the hole is clean and free from
burrs. Gently start the pin straight into the hole and tap
lightly with a soft hammer.
10. If the unit is equipped with an outboard bearing,
guide the bearing into it's recess in the shaft end cover.
This is a light press fit. lt may be necessary to lightly tap
the bearing into the bore.