TM 5-3810-307-24-2-2
10 mm, 15 mm
CAUTION
Be sure timing pin is disengaged before
rotating the engine.
Remove the crankshaft pulley and wire pointer.
Rear Seal - Installation (0-81)
Inspect the crankshaft flange and rear cover for dirt and
damage. Use a cleaning pad, Part No. 3823258, to re-
move dirt or rust deposits. Wipe the crankshaft flange
dry.
Install the rear cover and gasket. Do not tighten the
capscrews to the correct torque value at this time.
The replacement rear seal has a pilot tool installed. Do
not remove the pilot tool at this time.