TM 5-3810-307-24-2-2
Apply a mild soap to the rubber outside diameter of
the oil seal.
Use the alignment and installation tool packaged in
the seal kit. Drive the seal into the housing until the
driver bottoms.
NOTE
Alternately, drive the seal at the 12, 3, 6 and
9 o'clock positions to install the seal square
to the crankshaft flange.
Make sure the seal housing is level with both sides of
the cylinder block oil pan rail. Tighten the rear cover
capscrews.
Torque Value: 7 Nm
[80 in-Ib]
Remove the seal pilot tool. Trim the gaskets even
with the oil pan mounting surface.
Suction Tube - Installation (0-82)
Position the suction tube and gasket on the cylinder
block.