TM 5-3810-307-24-2-2
Operate the engine at the high idle throttle position until
the coolant temperature is 70C [160F].
Shut off the engine.
Drain the lubricating oil pan. Install the drain plug, and
fill the oil pan to the high level mark on the dipstick with
preservative oil.
NOTE
Fuel system preservative oil must meet
Federal Specification VV-L-800C. (Example:
Daubert Chemical NoxRust No. 518.)
Disconnect the fuel supply tube at the fuel filter and the
injector return tube at a convenient place.
NOTE
Fuel system preservative oil must meet
Federal Specification VV-L-800C. (Example:
Daubert Chemical NoxRust No. 518.)
Fill two containers, one with diesel fuel and the other
with preservative oil. Put both fuel tubes into the
container of diesel fuel.
Start the engine and, when operating smoothly, put the
fuel supply tube into the container of preservative oil.
Remove the injector return tube from the diesel fuel
container. When the preservative oil flows from the
tube, shut off the engine.
Connect the fuel supply tube to the fuel filter, and put a
cap on the ends of all the other fuel tubes.
14-26 C-1