TM 5-3810-206-35
KEY to fig. 3-46:
1
Pointer
5
Housing
9
Plug
13
Ring gear
2
Capscrew (2 rqr)
6
Gasket
10
Lockwasher (13 rqr)
14
Flywheel
3
Lockwasher (6 rqr)
7
Plate
11
Bolt (4 rqr)
15
Lock
4
Cover
8
Capscrew (4 rqr)
12
Bolt (9 rqr)
16
Screw (9 rqr)
Figure 3-46. Flywheel and flywheel housing, exploded view.
four capscrews (1), lockwasher (2), flat-washers (3),
(2) Remove starter motor and solenoid (TM 5-
blower drive cover (4) and gasket (5) from housing (7).
3810-206-12).
Discard the gasket (5).
(3) Remove flywheel (para 3-39).
(11) Remove seal (24) from housing (7).
(4) Remove oil pan (para 3-44) and disconnect
(12) Remove capscrews (21), lockwasher (20),
oil return line from housing.
nuts (19), rear plate (16), and gasket (17) from engine.
(5) Remove two of the 13 bolts securing
(13) Install flywheel housing by reversing the
housing to engine and install guide studs in their place to
procedure in steps (1) through (12) above.
facilitate removal.
b. Cleaning, Inspection, and Repair.
(6) Remove all bolts (11 and 12, fig. 3-46) and
(1) Clean all parts and dry thoroughly before
lockwashers (10) then slide housing out on-guide studs.
inspection or installation.
Remove housing (5) and gasket (6) from engine.
(2) Inspect the housing and rear plate for
(7) Remove
pointer
(1),
capscrew
(2),
cracks, breaks, elongated holes, or damaged threaded
lockwasher (3), and cover (4) from housing (5).
surfaces. Inspect mounting hardware for burs or other
(8) Remove four capscrews (8), lockwasher and
damage.
plate (7) from housing (5).
(3) Repair or replace defective housing or rear
(9) Remove plug (9) from housing (5).
plate. Replace all gaskets, and defective seals.
(10) Install flywheel housing by reversing the
procedures in steps (1) through (9) above.
b. Cleaning, Inspection, and Repair.
Clean,
3-41.
Flywheel Housing (Engine Model D333TA)
inspect, and repair flywheel housing in manner similar to
a. Removal and Installation.
that described in paragraph 3-40b above.
(1) Remove the engine (para 2-9).
3-57
