TM 5-3810-206-35
KEY to fig. 4-20:
1
Nuts (44 rqr)
16
Cover
29
Cap
38
Segment (2 rqr)
2
Case
17
Felt
30
Sleeve bearing
39
Sleeve bearing
3
Cap
18
Thumbscrew
(3 rqr)
40
Retainer plate
4
Gasket
(6 rqr)
31
Sleeve bearing
41
Lockwire
5
Plate
19
Breather
32
Frame
42
Capscrew (4 rqr)
6
Bolt (4 1 rqr)
20
Cover
33
Sleeve bearing
43
Pipe plug (2 rqr)
7
Cap
21
Capscrew
(2 rqr)
44
Retainer plate
8
Bolt (3 rqr)
22
Lockwasher
34
Sleeve bearing
45
Sleeve bearing
9
Cap
23
Gasket
(2 rqr)
(2 rqr)
10
Bolt (4 rqr)
24
Bolt
35
Sleeve bearing
46
Fitting (3 rqr)
11
Seal
25
Sleeve bearing
(3 rqr)
47
Bushing (3 rqr)
12
Seal
26
Pin (4 rqr)
36
Sleeve bearing
48
Segment (2 rqr)
13
Washer (8 rqr)
27
Cap
(2 rqr)
49
Nut (8 rqr)
14
Nuts (8 rqr)
28
Nut (4 rqr)
37
Sleeve bearing
50
Cotterpin (8 rqr)
15
Gasket
Figure 4-20. Retooling frame, exploded view.
(2) Support weight of bracket (9), then remove
(4) Remove bearing (3) and flatwasher (4) from
two nuts (7), lockwashers (8), and bolts (17) from
bracket (9). Remove fitting (14) from bushing (15), then
bracket (9).
remove bushing (15) from shaft (10).
(3) Remove nut (7), lockwasher (8), screw (16).
(5) Install front hook rollers by reversing
and bracket (9) from revolving frame.
procedure in steps (4) through (1) and a above.
4-29
