Thermostat Cover and Thermostats - TM-5-3810-207-20

Water Pump, Fan Pulley, and Hydraulic Steering Pump

TM-5-3810-207-20 Crane-Shovel Basic Unit Truck Mounted: 20 Ton 3/4 Cu.Yd. Gasoline Driven (Quickway Model M-200) Non-Winterized Manual
Page Navigation
157

TM 5-3810-207-20/TO 36C23-3-37-12 Figure 155. Carrier engine radiator Shroud, removal and installation. (5) Adjust the hydraulic steering pump belt and the three fan belts (TM 5-3810-207- 10). (6) Fill the cooling system to proper level (TM 5-3810-207-10). 259. Thermostat Cover and Thermostats a. Removal. (1) Drain the cooling system (TM 5-3810-207- 10). (2) Remove the hoses from the thermostat cover, radiator, and water pump (par. 257). (3) Remove the carrier engine thermostat cover and the two thermostats as instructed on figure 158. b. Test. (1) Place the thermostats in a pan of water and heat the water until the thermostats start to open. They should start to open at 160° F. and should be fully opened at 180° F. (2) Allow water to cool with the thermostats in it. Test the temperature of the water at the time the thermostats start to close and again when they are fully closed. The thermostats should start to close at 175 ° F. and be fully closed at 155 ° F. c. Cleaning and Inspection. (1) Clean all parts with an approved cleaning solvent. (2) Inspect the thermostats for proper operation and other damage. Replace defective thermostats. (3) Inspect all other parts for cracks, breaks, and other damage. Replace all defective parts. 201

Privacy Statement
Press Release
Contact