TM 5-3810-207-20/TO 36C23-3-37-12
E-Electrical connections for testing voltage regulator
Figure 9 - Continued.
to operating to idle speed to make
sure adjustments are stable.
(e)
Remove
adapters
and
connect
cables.
74. Distributor
a.
Removal. Remove the distributor as instructed
on figure 10.
Note.
Before removing the distributor, for
reassembly
place
identification
marks on the distributor housing in
relation to the distributor rotor.
b.
Cleaning, Inspection, and Repair.
(1)
Clean the distributor with an approved
cleaning solvent and dry thoroughly.
(2)
Inspect the distributor for cracks, breaks,
and other damage. Replace defective
distributor.
(3)
Lubricate the distributor (LO 5-3810-207-
20).
c.
Installation. Refer to the identification marks
placed on the distributor housing and install the
distributor as illustrated on figure 10.
75. Distributor Points, Coil, Condenser, Resistor,
and Rotor Cap
a.
Removal.
(1)
Remove the distributor (par. 74).
(2)
Disassemble the distributor as illustrated
on figure 11.
b.
Cleaning, Inspection, and Repair.
(1)
Clean all parts with an approved cleaning
solvent and dry thoroughly.
36
