(2) Install the drum and wheel (para. 226).
d. Adjustment. Adjust the rear brakeshoes in a similar
manner as for front brakeshoes (para. 241).
Section XXVI. PROPELLER SHAFTS AND CONTROLS
243. General
(2) Install the front axle the tandem, and the rear
The carrier is equipped with four propeller shafts.
axle propeller shaft in a similar manner.
Each propeller shaft is equipped with two universal
245. Transmission Control Rod
joints and one slip joint. Each has two flanged yokes for
a. Removal and Disassembly.
Remove and
connecting to driving and driven components. The
disassemble the transmission control rod as illustrated on
propeller shafts are of tubular-type construction.
b. Cleaning, Inspection, and Repair.
244. Transmission-To-Transfer Case Prop Her Shaft
(1) Clean all parts with an approved cleaning
a. Removal.
solvent.
(1) Remove the transmission-to-transfer case
(2) Inspect all parts for excessive wear, bends,
propeller
shaft
in
the
numerical
breaks, and other damage. Replace or repair
sequences as instructed on figure 149.
all defective parts as necessary.
(2) Remove the rear axle, the tandem, and
c. Reassembly and Installation. Reassemble and
the front axle propeller shafts in a similar
install the control rod assembly as illustrated on figure 150.
manner.
b. Cleaning, Inspection, and Repair.
246. Transfer Case Shifter Levers and Controls
(1) Clean all parts with an approved cleaning
solvent.
as instructed on figure 151.
(2) Inspect the spider bearings for excessive
b. Cleaning, Inspection, and Repair.
wear and other damage. Replace spider
(1) Clean all parts with an approved cleaning
bearings as necessary.
solvent.
c. Installation.
(2) Inspect-all parts for breaks, bends, and other
(1) Install the transmission-to-transfer case
damage. Repair or replace all parts as
propeller shaft in the reverse of the
necessary.
numerical sequence as illustrated on
illustrated on figure 151.
AGO 6819A
166
