clutch is engaged. The facing wear of the driven disks is
b. Inspection and Repair. Inspect all parts for
compensated by adjusting the threaded internal adjusting
excessive wear or damage.
Replace or repair all
ring to restore the original spring pressure.
defective or damaged parts. The proper clearance
443. Carrier Engine Clutch Assembly Removal and
between the pressure plate driving lugs and slots of the
Disassembly
flywheel ring is from 0.004 to 0.008 Inches.
a. Removal.
445. Carrier Engine Clutch Assembly Reassembly
and Installation
(1) Disconnect the propeller shaft (para. 2 4).
a. Reassembly. Reassemble the carrier engine
(2) Remove the clutch housing (para. 489).
clutch assembly in the reverse of the numerical,
(3) Remove the carrier engine clutch assembly
sequence as illustrated on B, figure 103.
as instructed on figure 228.
b. Installation.
b. Disassembly. Disassemble the carrier engine
(1) Install the carrier engine clutch assembly as
clutch assembly in numerical sequence as illustrated on
illustrated on figure 228.
B, figure 103.
(2) Install the clutch housing (para. 441).
444.
Carrier Engine Clutch Assembly Cleaning,
Inspection and Repair
(3) Connect the propeller shaft (para. 244).
a. Cleaning. Clean the disk assembly with a dry
cloth. Clean remaining parts with an approved cleaning
solvent and dry thoroughly.
Section XL. CARRIER ENGINE FLYWHEEL AND FLYWHEEL HOUSING
446. General
b. Disassembly.
Disassemble the flywheel and
The carrier engine flywheel is attached to the
flywheel housing in numerical sequence as
crankshaft flange with six capscrews, lockwashers, and a
illustrated on figure 230.
lockwire. One of the cap screws is offset 1/16 inch. A
448. Carrier Engine Flywheel and Flywheel Housing,
corresponding hole Is located in the crankshaft flange so
Cleaning, Inspection, and Repair
the flywheel can be assembled in but one position. It is
a. Cleaning. Clean all parts with an approved
very important to tighten the flywheel capscrews securely.
cleaning solvent and dry thoroughly.
The flywheel housing provides support for mounting the
b. Inspection and Repair. Inspect all parts for
clutch housing and transmission assemblies as well as
excessive wear and damage. Replace or repair all
affording protection to the clutch mechanism and flywheel
defective parts. Maximum run-out of the flywheel should
ring gear.
not exceed 0.002 indicator reading.
447. Carrier Engine Flywheel and Flywheel Housing
449. Carrier Engine Flywheel and Flywheel Housing
Removal and Disassembly
Reassembly and Installation
a. Remove.
a. Reassembly.
Reassemble the flywheel and
(1) Remove the starter assembly (para. 102).
flywheel housing in the reverse of the numerical sequence
(2) Remove the clutch assembly (para. 448).
as illustrated on figure 230.
(3) Remove the flywheel and flywheel housing
as instructed on figure 229.
249
