555.
Carrier Front Spring Assembly
Removal and Disassembly
a.
Removal. Remove the carrier front spring
assembly as instructed on figure 264.
b.
Disassembly. Disassemble the carrier front
spring assembly as illustrated on figure 265.
556.
Carrier Front Spring Assembly
Cleaning, Inspection, and Repair
a.
Cleaning. Clean all parts with an approved
cleaning solvent and dry thoroughly.
b.
Inspection and Repair. Inspect all parts for
excessive wear or damage. Replace or
repair all defective parts.
557.
Carrier Front Spring Assembly
Reassembly and Installation
a.
Reassembly. Reassemble the carrier front
spring assembly as illustrated on figure 265.
b.
Installation. Install the carrier front spring
assembly as illustrated on figure 264.
Figure 264. Carrier front spring and axle assembly,
removal and installation.
Figure 265. Carrier Front spring assembly.
Section LXVIII. TORQUE ROD ASSEMBLY
558.
General
carrier at the rear saddle bracket. The ball stud and
socket assembly of the torque rod is so designed that
Each rear axle of the carrier has an automotive-type
the torque generated at the axle is minimized at the
torque rod; one end attached to the upper axle housings
frame.
and the other end of the torque rod is attached to the
AGO 6819A
297
