Figure 266. Torque rod assembly, removal and
installation.
559.
Torque Rod Assembly Removal and
Disassembly
a.
as instructed on figure 266.
b.
assembly in numerical sequence as instructed on
560.
Torque Rod Assembly Cleaning and
Inspection
a.
Cleaning. Clean all parts with an approved
cleaning solvent and dry thoroughly.
b.
Inspection. Inspect all parts for excessive
wear and damage. Replace all defective
parts as necessary.
561.
Torque Rod Assembly Reassembly and
Installation
Figure 267. Torque rod assembly, exploded view.
a.
Reassembly. Reassemble the torque rod
b.
assembly in the reverse of the instructions on figure
as illustrated on figure 266.
Section LXIX. EQUALIZING BEAM ASSEMBLY
562. General
mounted beam ends provide axle movement
independent of the carrier frame, since the vertical
Two equalizing beams serve as the rear suspension for
movement of either wheel or axle is about the center
the carrier frame and rear axles to which each end of
mounting of
the beams are bolted. The ball and socket axle
AGO 6819A
298
