Figure 269. Equalizing beam assembly exploded view.
(6)
Use a suitable lifting device to raise
the carrier, and roll the rear axle
assemblies from under the carrier.
Block the carrier up in this position.
(7)
Remove the rear axles (para. 227).
(8)
Remove the carrier rear axle
differential assemblies as instructed
on figure 270.
b.
Disassembly. Disassemble the carrier rear
axle differential assemblies in numerical sequence as
illustrated on figure 271.
568.
Carrier Rear, Rear Axle Differential
Assemblies, Cleaning, Inspection, and
Repair
a.
Cleaning. Clean all parts with an approved
cleaning solvent and dry thoroughly.
b.
Inspection and Repair. Inspect all parts for
Figure 270. Carrier rear axle differential assembly,
excessive wear and damage. The pre-load torque for
removal and installation
bearings mounted in bearing cage is 5 to 15 pounds-
inch. Install or remove shims between bearing cage and
AGO 6819A
300
