TM 5-3810-231-12
ITEM
PAR REF
4
FIRE EXTINGUISHER. Inspect for broken seal.
5
BATTERIES. Tighten loose cables and mountings. Remove corrosion. Inspect for cracks and leaks.
Fill to 3/8 inch above the plates. Clean vent hole in filler cop before installing. In freezing weather run
engine a minimum of 1 hour after adding water. (Weekly).
6
DRIVE CHAINS. Inspect for wear and improper adjustment.
7
FUEL TANK. Add fuel as required.
8
OIL LEVEL GAGE. Add oil as indicated by level gage. Reference Current L.O.
9
AIR COMPRESSOR. Clean intake filter, drain condensate (Weekly).
10
FAN V-BELTS. Proper adjustment is a deflection of 3/4 inch midway between pulleys. (Weekly).
11
RADIATOR. Proper coolant level is 2 inches below filler neck.
12
GENERATOR V-BELTS.
Proper adjustment is a deflection of 1/2 inch midway between pulleys.
(Weekly).
13
FUEL FILTERS. Drain water and sediment, inspect for leaks. (Weekly).
14
CABLES. Inspect for damage.
15
CRAWLER TRACK AND SUPPORT ROLLERS. Inspect for wear and damage.
NOTE
OPERATIONAL TEST. During operation observe for any unusual noise or vibration.
MEC 3810-231-12/17 (2)
Figure 17 - Continued.
43
