TM 5-3810-231-12
Figure 48. Batteries, cables, and battery box, removal and installation.
b. Repair. Repair a broken wire by cutting a length
(1) Clean battery charging receptacle with
an approved cleaning solvent and dry
of wire and taping it along the harness. Install two clips
thoroughly.
at either end and remove the broken wire of the
harness. Secure the end of the new wire to the
(2) Inspect for cracks, breaks, or other
connection.
damage.
Replace a damaged or
defective receptacle.
93. Battery Charging Receptacle
c. Installation. Refer to figure 50 and install
battery charging receptacle.
a. Removal.
Refer to figure 50 and remove
battery charging receptacle. Tape lead ends to prevent
battery discharge.
b. Cleaning and Inspection.
79
