TM 5-3810-231-12
Figure 45. Starter and solenoid test wiring diagram
(5) Inspect the commutator for pits, burns,
and other damage, if commutator is
defective replace the starter.
c. Installation. Install the starter assembly as
illustrated on figure 46.
d. Brush Replacement.
(1) Removal.
(a) Remove the starter as instructed on
(b) Remove the cover band.
(c) Remove the brushes as instructed
on figure 47.
(2) Installation.
(a) Install the brushes as illustrated on
Figure 46. Solenoid and starter, removal and
Fit brushes to
installation
commutator. Place new brush in
position with a piece of medium
(4) Inspect the starter assembly for proper
grade sandpaper under the brush
operation, wear, and other damage.
with the back (smooth side) of the
Replace a defective starter.
sandpaper held closely in contact
77
