c. Cleaning, Inspection and Repair.
Key to Figure 5-46..
(1) Clean all metal parts with an approved
1.
Base assembly
cleaning solvent and dry thoroughly.
2.
Outer lever assembly
(2) Inspect all parts for cracks, breaks or
3.
Bearing, flanged
other damage. Repair or replace defective parts.
d. Reassembly. Reassembly operator's seat in
4.
Pin, drive
5.
Center lever assembly
reverie of the numerical sequence shown on figure 5-46.
6.
Bering, housing L.H.
e. Installation. Install carrier operator's seat (TM 5-
7.
Bearing housing R.H.
8102-2-12).
8.
Roller & bearing assy.
9.
Stud
5-38. Carrier Cab Heater.
10.
Snap ring
a. Removal. Remove cab heater (TM 5-3810-232-
11.
Washer, plain
12).
12.
Lockwasher (38/8)
b. Disassembly. Disassembly cab heater as shown
13.
Nut, hex (3/8-16)
in figure 5-47.
14.
Bearing, flanged
15.
Washer, plain
16.
Kit, shock lever assy.
17.
Shock lever assy.
18.
Hinge shaft, shock
19.
Hinge shaft, shock rear
20.
Roll pin
22.
Shock absorber assy.
23.
Bearing kit, shock absorber
24.
Bearing, flanged
25.
Retainer. T-bar
26.
Yoke
27.
Torison bar set (2)
28.
Side panel ma. L.H.
29.
Side panel assy. R.H.
30.
Adjuster screw & lover my.
31.
Spring, tension
32.
Washer plain
33.
Thrust ball bearing
34.
Adjuster pin
35.
Washer, plain
36.
Lube fittings
37.
Roller, nylon
38.
Washer, plain (5/16)
39.
Lockwasher (5/16)
40.
Nut, hex 5/16-18)
41.
Adjuster kit
42.
Capscrew (5/16-18x5/8)
43.
Bumper
45.
Cover assembly
46.
Back cushion assembly
47.
Cover assembly
48.
Universal riser kit
49.
Fastener clip cushion
50.
Ride level indicator
5-99
