c. Cleaning, Inspection and Repair.
e. Installation.
Install utility blade assembly (TM
(1) Clean all parts with an approved cleaning
56-810-232-12).
solvent.
(2) Inspect all parts for cracks, breaks, and
5-42. Push Beams
other damage. Repair by welding or replace defective
a. Removal. Remove push beams as instructed on
parts.
d. Reassembly.
Reassemble utility blade in
reverse of numerical sequence shown on figure 5-49.
Figure 5-50. Utility blade push beam, removal and installation.
b. Disassembly. Disassemble push beams as
(2) Inspect all parts for cracks, breaks, and
signs of structural damage. Repair by welding, or
shown on figure 5-49.
c. Cleaning, Inspection and Repair.
replace defective parts as necessary.
d. Reassembly.
Reassemble push beams as
(1) Clean all parts with an approved cleaning
shown on figure 5-49.
solvent.
e. Installation. Install push beams as instructed on
Section XII. ROTATING FRAME RING GEAR
(1) Remove the crane boom assembly (TM 5-
5-43. General
3810-232-12).
A dual flanged center, hub-type ring gear, is bolted to the
(2) Remove the crane rotating frame base
carrier frame and serves as the swing or tracking gear in
assembly (para 6-31).
which the crane assembly rotating gear and rollers
(3) Remove the rotating frame ring gear as
operate.
instructed on figure 5-51.
5-44. Rotating Frame Ring Gear
a. Removal.
5-104
