Key to Figure 6-17. (2)
35 Nut
1 Nut self-locking
36 Screw, cap
2 Spacer
37 Washer, lock
3 Screw cap
38 Bar clutch keeper
4 Washer, lock
39 Block, adjustment
5 Pin, lock
40 Spider
6 Pin
41 Collar
c. Cleaning, Inspection, and Repair.
7 Bushing
8 Shim
(1) Clean all parts in an approved cleaning
9 Lever, live
solvent and dry thoroughly.
10 Spacer
(2) Inspect all parts for excessive wear or
11 Nut
damage. Replace or repair all defective parts.
12 Pin
d. Reassembly. Reassemble the swing shaft
13 Screw, adjusting
assembly in the reserve of the numerical sequence as
14 Link, dead
illustrated on figure 6-17.
e. Installation.
15 Pin, pivot
16 Band assembly
(1) Install the swing shaft as instructed on
17 Band
18 Rivets
(2) Install shifter levers on shifter collars or
19 Lining kit
horizontal reversing shaft clutches (TM 5 3810-232-12).
20 Nut
(3) Install countershaft assembly (para 6-16).
21 Lockwasher
(4) Install the hoist drum shaft (para 6-14)
22 Screw, cap
23 Screw, cap
24 Washer. lock
25 Bar, adjustment
26 Bar, adjustment
27 Pin
28 Yoke, toggle
29 Link, dead
30 Pin, cotter
31 Pin
32 Link, toggle
33 Bushing
34 Screw set
Section IX. CRANE VERTICAL REVERSING SHAFT ASSEMBLY
(2)
Remove the vertical reversing shaft
6-21. General
assembly.
(a) Remove four screws (1, fig. 6-18),
The crane vertical reversing shaft assembly is driven by
two lock plates (2), end plate (3) and shims (5, 6).
the swing shaft assembly through beveled gears. A
(b) Using a suitable hoist remove the
machined gear on the vertical reversing shaft meshes
gear (8) and shaft (11) separately.
with a gear on the swing shaft and another meshes with
b. Disassembly.
Disassemble the vertical
a gear on the vertical swing shaft.
reversing shaft assembly in numerical sequence as
shown
on
6-22. Crane Vertical Reversing Shaft Assembly
a. Removal.
(1) Remove the swing shaft assembly (para
6-26
