c. Cleaning, Inspection and Repair.
iary shaft assembly in reverse of the numerical sequence
shown on figure 6-22.
(1) Clean all parts with an approved cleaning
e. Installation.
solvent and dry thoroughly.
(1) Install the crane auxiliary shaft as
(2) Inspect all parts for excessive wear and
instructed on figure 6-21.
damage. Replace or repair damaged or defective parts.
d. Reassembly. Reassemble the crane auxil
(2) Install the hoist drum shaft assembly and
crane cab assembly (para 6-14).
Section XII. CRANE GANTRY FRAME
6-27. General
6-28. Crane Gantry Frame Removal
a. Remove the crane gantry sheave block (TM 5-
The crane gantry frame is a supporting device used to
support the boom. It is mounted on the crane frame by
3810-232-12).
b. Remove the crane cab assembly (para 2-8).
means of pins and is constructed of heavy steel.
c. Remove the crane gantry frame from the
revolving frame as instructed on figure 6-23.
Figure 6-23. Crane gantry, frame, removal and installation.
6-33
