TM 5-3810-289-34
Table 2-1. Continued
Item
FSN or
Paragraph
Use
part No.
reference
Valve tester
ST-417
Check valves and seats for leakage.
49108980645
Reamer driver
ST-219
Hard driver to turn main bearing bore reamer.
Valve seat insert kit
ST-257
Hold and drive cutter when removing insert.
51803453708
Sleeve expander
ST-297
Seal upper portion of injector sleeve.
51207664756
Ball joint vise
ST-302
Holds fuel pump for disassembly.
Injector seat cutter
ST-379
Cut injector seat to give proper seat and tip
51207664757
protrusion.
Valve guide driver
ST-740
Install valve guides.
Cutter
ST-S25
Cut injector sleeve.
Piston ring compressor
ST-755
Install piston into skirt end of liner.
Chamfering tool
ST-861
Chamfer tapered piston pin bushing bore.
49109991498
Flange puller
ST-887
Pull crankshaft hub.
Wrench adapter
ST-669
Adapts torque wrench to locknuts of valve
M 1302A
crossheads.
Spot facing tool
ST-542
Repair inlet and drain connection surfaces of
51207664754
injector body.
Pump mounting plate
ST-546
Hold fuel pump for disassembly.
Gage block
ST-547
Measure block counterbore depth.
51206907949
Seal tool assembly
ST-558
Guides rear cover and seal into position.
Wear gage
ST-560
Check ring groove wear.
51209991209
Valve facing machine
ST684
Grind valves.
Model-VS
Lifting fixture
ST-756
Lift engine for mounting.
Sleeve rolling tool
ST-819
Seal injector sleeve in lower seating area.
5130777529
Packing tool assembly
ST-835
Install preformed packing on throttle shaft
49109991505
of fuel pump.
Bead cutting tool
ST-839
Machine bead in sleeve seat area of bead.
Locating mandrel
ST-562
Measure connecting rod alinement.
Holding fixture
ST-569
Hold fuel injector for repair.
51203645417
Checking fixture
ST-570
Check inject plunger seating for leaks
51206907950
Holding fixture
ST-583
Hold cylinder head for disassembly.
49207119307
Cylinder liner driver
ST-594
Cylinder liner installation.
51209991206
Ring expander
ST-760
Expands piston ring for installation.
P407-R
Boring machine
ST-0526
Bore out new piston ring for installation
PM 9000D
Plate puller
ST-77S8
Used with cylinder liner puller.
Checking fixture
ST-561
Check rod alinement.
49109777507
Camshaft bushing driver.
ST-782
Replace camshaft bushing.
51209 39664
Mandrel and block
ST-605
Replace piston pin bushing.
Section II. TROUBLESHOOTING
2-4. General
2-5. Troubleshooting Chart
This section provides information for diagnosing and
In chart 2-1, each malfunction listed is followed by
correcting unsatisfactory operation or failure of the
probable causes of the trouble. The corrective action
crane-shovel and its components.
required is described opposite the probable cause.
2-2
