TM 5-3810-289-34
CHAPTER 2
DIRECT SUPPORT AND GENERAL SUPPORT
MAINTENANCE INSTRUCTIONS
Section I. REPAIRS PARTS, SPECIAL TOOLS, AND EQUIPMENT
2-1. Tools and Equipment
2-2. Special Tools and Equipment
Tools and equipment required to perform direct support
and general support maintenance on the Crane-Shovel
direct support and general support maintenance on the
are listed in table 2-1. References to graphs and
crane-shovel.
illustrations indicating the use of tools and equipment are
2-3. Maintenance Repair Parts
listed in the table.
Maintenance repair parts are listed and illustrated in TM
5-3810-289-35P.
Table 2-1. Special tools and equipment
Item
FSN or
Paragraph
Use
part No.
reference
Leakage tester
ST-990
Check injector cup for Ieaks.
Liner puller
ST-777
Pull cylinder liners from block.
51203645416
Camshaft bushing mandrel
ST-783
Replace camshaft bushing.
67342
Pulley assembly tool
ST-386
Assemble pulley.
Mandrel
ST430
Tachometer drive assembly installation.
Puller
ST-709
Governor weight shaft removal.
Liner bore tool
ST-676
Resurface cylinder liner counterbore.
51330728366
Adapter plate
ST-679
Used with cylinder liner counterbore tool.
Mandrel set block
ST491
Replace rocker liner bushings.
34609991210
Guide spacer
ST-707
Press in new solid guides in lead.
Belt tension gage
ST-968
Check belt tension.
Standard puller
ST-647
Remove accessory drive pulley.
Grinding machine
ST-685
Grind valve seats.
Model-SG
Seal driver
ST480
Install crankshaft oil seal.
Regrooving tool
ST483
Regroove top ring groove on piston.
Hold-down adapter
ST-1010
Hold-down injector sleeve for repair.
Plug gage
ST-504
Check piston pin bushing diameter.
Oil assembly tool
ST419
Assemble drive cover on fuel pump.
51208968097
Packing tool assembly
ST422
Install O-ring on throttle shaft of fuel pump.
Valve spring compressor
ST448
Remove valves and springs from cylinder head.
51209813114
Seat cutter pilot
ST-843
Guide seat cutter in drill press.
Grooving tool
ST-913
Regroove cylinder head.
49109991499
Holding tool
ST-923
Hold injector sleeve while testing for cracks.
Cup wrench
ST-934
Remove injector cup.
Guide puller
ST-667
Remove valve cross-head guides.
51209813110
Grooving tool
ST-597
Regroove cylinder head
Holding tool
ST-383
Hold injector sleeve while testing for cracks.
51207664758
Drill ream fixture
ST406
Ream dowel holes in flywheel housing.
Checking bar
ST409
(heck bore alignment .
Main bearing bore reamer
ST401
Ream out main bearing bore.
51209991266
2-1
