POWER STEERING SYSTEM
SECTlON X
3. Remove lever shaft (10) end bearing assembly (9) by
1. Loosen the damp that secures the steering column to
pushing on the end of the nutput shaft.
the steering gear.
4. Remove end cover (6).
2. Disconnect the drag link from the steering arm of the
steering gear.
6. Remove end cover shims (19).
3. Remove the steering gear mounting bolts and remove
6. Pull cam assembly (18) out of the housing.
the steering gear.
7. Ball bearing (17), retainer assembly (15), and bell cups
DISASSEMBLY. To disassemble the steering gear proceed
(16) can now be removed from the worm shaft.
as follows:
8. Using a soft bar the diameter of the bushing, drive bush-
1. Remove lever shaft nut (1, Figure 10-6). lockwasher (2).
ings (5) and seal (4) out of the housing.
and steering arm (3) from the housing.
ASSEMBLY. To assemble the steering gear, proceed es
NOTE
follows:
1. Install bearings (17), ball cups (16), end retainers (15)
The housing is filled with grease and will run out
on cam shaft (18).
when the side cover is removed.
2. Insert the bushings in the housing. Use a soft bar the
2. Remove side cover (12).
Figure 10-6. Steering Gear (53Z341)
10-6
