TM 5-3810-295-34
Figure 14-7. Cylinder head torquing sequence
Section IV. INJECTORS, PUSH RODS AND TAPPETS
e. Place injector tappets (8) in a suitable holding fix-
14-12. Removal and Disassembly
ture and remove lock wire (9).
Refer to figure 14-8.
f Press roller pin (10) from body. Discard lock wire
NOTE
(9) and pin (10).
Mark push rods for installation in identical
NOTE
position during reassembly.
If push rods and tappets are to be reused, best
a. Remove push rods (1) and (2) from cylinder head.
results will be attained when the push rods
b. Remove screws (3), lock washers (4), and tappet
are kept with their mating tappet.
guides (5).
g. Remove injector roller (11).
c. Pull tappet assemblies (8) and (13) from block
h. Press or knock out cam follow socket (12) with a
with a wire hook or small slide hammer.
small round punch.
d. Remove springs (6) and (7) from each tappet as-
14-7
