TM5-3810-305-10
d. Swing lift arm and mast out of the way.
e. Shut engine off.
2. Disconnect winch extension hoses as follows:
a. Relieve pressure in winch circuits by
turning ignition switch ON, holding on
anti-two block BY-PASS switch and oper-
ating winch lever in both directions sev-
eral times until pressure is released. Turn
ignition switch OFF.
Turn the face during the follow-
ing procedure to avoid having
hydraulic oil splash in face or
eyes. Failure to follow this
procedure could cause SERIOUS
INJURY.
b. Disconnect winch extension hoses H-10
and H-11 (Figure 5-15) from both upper-
structure and underneath carrier. Do not
connect winch lines to rotary manifold at
this time. Install dust caps on quick
disconnect fittings on valve under carrier.
WINCH
HOSES
Figure 5-14. Extension Hoses
EXTENSION
HOSES
Figure 5-15. Quick Disconnect Fittings
5-36
