TM 5-3810-305-23
0079
REMOVAL
NOTE
Tag and identify all wire assemblies before disconnecting to aid in installation. Remove tags
following maintenance.
1.
Disconnect wire harness plugs from receptacles on back wall of cab.
2.
Remove two clamps (Figure 1, Item 14) and wire (Figure 1, Item 15) from heater and circuit breaker.
3.
Disconnect cab main harness from cab floor ground (Figure 1, Item 12), circuit breaker (Figure 1, Item 11),
sloping dash panel (Figure 1, Item 10), horn (Figure 1, Item 7), defroster fan (Figure 1, Item 5), brakelight
switch (Figure 1, Item 6), wiper motor (Figure 1, Item 2), turn signal switch (Figure 1, Item 17), speedometer
(Figure 1, Item 3), headlights (Figure 1, Item 1), and speedometer alarm (Figure 1, Item 4).
4.
Remove cab main harness mounting clamps (Figure 1, Item 13), capscrews (Figure 1, Item 8), nuts
(Figure 1, Item 9), and tiedown straps (Figure 1, Item 16). Discard tiedown straps.
5.
Remove cab main harness from cab.
END OF TASK
CLEANING
Clean parts IAW General Maintenance Instructions (WP 0162).
END OF TASK
INSPECTION
1.
Inspect parts IAW General Maintenance Instructions (WP 0162).
2.
Repair cab main harness, if necessary.
END OF TASK
0079-2
03/15/2011Rel(1.8)root(maintwp)wpno(M00085)
