TM 5-3810-305-23
0078
INSPECTION
1.
Inspect parts IAW General Maintenance Instructions (WP 0162).
2.
Repair wire harness, if necessary.
END OF TASK
INSTALLATION
1.
Position main engine wiring harness (Figure 2, Item 12) in vehicle.
2.
Connect main engine wiring harness (Figure 2, Item 12) at shunt (Figure 2, Item 21), hydraulic valve bank
(Figure 2, Item 6), winch valve (Figure 2, Item 10), fuel shutoff toggle switch (Figure 2, Item 8), front outrigger
solenoid valve (Figure 2, Item 9), collector ring (Figure 2, Item 5), fuel sender (Figure 2, Item 13), transmission
temperature sender (Figure 2, Item 4), axle centering light switch (Figure 2, Item 14), oil pressure sender
(Figure 2, Item 17), backup alarm (Figure 2, Item 19), rear outrigger solenoid valve (Figure 2, Item 3), water
temperature sender (Figure 2, Item 20), alternator (Figure 2, Item 2), starting motor solenoid and starting motor
relay (Figure 2, Item 1), speedometer sender (Figure 2, Item 7), taillights (Figure 2, Item 16), fuel solenoid
(Figure 2, Item 18), and turn signals (Figure 2, Item 15).
3.
Install new tiedown straps, new lockwashers, and clamps to secure main engine wiring harness.
2
1
3
19
20
18
21
4
17
8
567
16
15
14
13
11
12
10
M0164105
9
Figure 2.
Main Engine Wiring Harness Installation.
END OF TASK
03/15/2011Rel(1.8)root(maintwp)wpno(M00084)