TM 5-3810-305-23
0085
REMOVAL
1.
Remove four capscrews (Figure 1, Item 22) and split washers (Figure 1, Item 23) from side housing
(Figure 1, Item 8). Discard split washers.
2.
Remove two capscrews (Figure 1, Item 25) and lockwashers (Figure 1, Item 7) from side housing
(Figure 1, Item 8). Discard lockwashers.
3.
Remove two side housings (Figure 1, Items 8 and 9) and extruded spacers (Figure 1, Item 19) from
control assembly.
4.
Remove two access caps (Figure 1, Item 26) and decals (Figure 1, Item 24) from side
housing (Figure 1, Item 8).
5.
Remove three ball knobs (Figure 1, Item 4) from shift levers (Figure 1, Items 1, 3, and 5).
6.
Remove gate plate (Figure 1, Item 27) from control assembly.
7.
Remove position strips (Figure 1, Items 28, 29, and 30) from gate plate (Figure 1, Item 27).
8.
Remove two retaining rings (Figure 1, Item 10) and spacers (Figure 1, Item 11) from actuator
assembly (Figure 1, Item 21).
9.
Remove three time actuator assemblies (Figure 1, Item 21) and two spacers (Figure 1, Item 18) from
shaft (Figure 1, Item 20).
NOTE
The following step covers removal for one actuator assembly; removal of remaining actuators
is similar.
10.
Drive pin spring (Figure 1, Item 17) from actuator assembly (Figure 1, Item 21) and remove shift
lever (Figure 1, Item 5).
11.
Remove lever detent (Figure 1, Item 6) from actuator assembly (Figure 1, Item 21).
12.
Straighten ends of torsion springs (Figure 1, Items 2 and 13) extending through actuator assembly
(Figure 1, Item 21).
13.
Remove torsion springs (Figure 1, Items 2 and 13) and torsion spring shaft (Figure 1, Item 12) from
actuator assembly (Figure 1, Item 21). Remove torsion springs (Figure 1, Items 2 and 13) from torsion spring
shaft (Figure 1, Item 12).
14.
Remove balls (Figure 1, Item 16), springs (Figure 1, Item 15), and slugs (Figure 1, Item 14) from center actuator
assembly (Figure 1, Item 21).
0085-2
03/15/2011Rel(1.8)root(maintwp)wpno(M00092)
