TM 5-3810-305-23
0103
INSPECTION
1.
Inspect parts IAW General Maintenance Instructions (WP 0162).
WARNING
The brake linings contain asbestos. Wear protective breather respirator when performing
maintenance on the brake assembly and brake drum.
Care must be taken when cleaning the brake assembly. Clean the assembly as a whole
by using a solution of hot soapy water. Go over the assembly three times or enough to
be sure it is completely clean to prevent the asbestos fibers from being released into the
air and circulated in the maintenance area.
DO NOT use compressed air to dry the brake assembly. Let it air dry.
Failure to follow these warning may cause injury to death to personnel.
2.
Inspect all parts for wear, pitting, cracks, or corrosion and replace if necessary.
END OF TASK
INSTALLATION
1.
Install wheel cylinder (Figure 4, Item 2) and two bolts (Figure 4, Item 4) on brake spider
assembly (Figure 4, Item 6).
CAUTION
Copper sealing washers are not reusable. If previously tightened connection containing
copper sealing washer(s) is loosened, washer(s) must be replaced before retightening.
Failure to follow this caution may result in damage to equipment.
2.
Install dust shield (Figure 4, Item 1), six bolts and washers (Figure 4, Item 3), and banjo fitting assembly
(Figure 4, Item 5) on brake spider assembly (Figure 4, Item 6). Do not tighten until brake lines have
been connected.
0103-4
03/15/2011Rel(1.8)root(maintwp)wpno(M00114)
