TM 5-3810-305-23
FIELD MAINTENANCE
BRAKE ASSEMBLY MAINTENANCE
INITIAL SETUP:
Materials/Parts (cont.)
Tools and Special Tools
Sealant, Loctite 222 (WP 0170, Table 1, Item 55)
Tool Kit, General Mechanic's (WP 0171, Table 1,
Item 17)
Qty: 1
Wrench, Torque, 3/4 Inch Drive Ratcheting, 600 ft-
Tag, Marker (WP 0170, Table 1, Item 68) Qty: 1
lb (WP 0171, Table 1, Item 34)
Wrench, Torque, Click, Ratcheting 3/8 Inch Drive,
Personnel Required
75 ft-lb (WP 0171, Table 1, Item 36)
(Two)
Materials/Parts
References
Brake Fluid, Automotive (WP 0170, Table 1, Item
6) Qty: 1
Cap Set, Protective, Dust and Moisture Seal
(WP 0170, Table 1, Item 7) Qty: 1
Equipment Condition
Rag, Wiping (WP 0170, Table 1, Item 52) Qty: 1
Vehicle parked on level ground (TM
5-3810-305-10)
Boom in horizontal position and fully retracted (TM
5-3810-305-10)
Planetary wheel end removed (WP 0096)
Battery cables disconnected (WP 0076)
WARNING
The brake linings contain asbestos. Wear protective breather respirator when performing
maintenance on the brake assembly and brake drum.
Care must be taken when cleaning the brake assembly. Clean the assembly as a whole
by using a solution of hot soapy water. Go over the assembly three times or enough to
be sure it is completely clean to prevent the asbestos fibers from being released into the
air and circulated in the maintenance area.
DO NOT use compressed air to dry the brake assembly. Let it air dry.
Failure to follow these warning may cause injury to death to personnel.
0103-1
03/15/2011Rel(1.8)root(maintwp)wpno(M00114)