TM 5-3810-305-23
0146
REMOVAL - Continued
CAUTION
Wipe area clean around all connections to be opened during removal. Cap lines and
hoses and plug openings after removing lines. Contamination of system could result in
premature failure.
NOTE
Tag hoses prior to removal to ensure correct installation.
Use a container to catch any fluid that may drain from hoses or system. Dispose of
fluid IAW local policy and ordinances. Ensure all spills are cleaned up.
1.
Turn dipstick cap 1/4 turn to safety notch to relieve pressure.
2.
Disconnect 14 hoses and fittings (Figure 1, Item 2) from control valve (Figure 1, Item 1).
3.
Disconnect four control cables and disconnect assemblies (Figure 1, Item 3) from control valve
(Figure 1, Item 1).
4.
Remove three nuts (Figure 1, Item 4), lockwashers (Figure 1, Item 5), and capscrews (Figure 1, Item 6).
Discard lockwashers.
5.
Remove control valve (Figure 1, Item 1) from vehicle.
2
1
3
LRT110--2378
LRT110 2378
4,5,6
M0340105
Figure 1. Hydraulic System Valve Bank Removal.
END OF TASK
03/15/2011Rel(1.8)root(maintwp)wpno(M00163)