TM 5-3810-305-23
0152
CLEANING - Continued
WARNING
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle
pressure when drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when
cleaning components. DO NOT direct compressed air against human skin. Make sure air
stream is directed away from user and other personnel in the area. To prevent injury, user
must wear protective goggles or face shield. Failure to follow this warning may result in injury
to personnel.
2.
Dry parts with compressed air.
END OF TASK
INSPECTION
1.
Inspect parts for wear, burrs, nicks, and corrosion IAW General Maintenance Instructions (WP 0162).
Replace worn or damaged parts.
2.
Polish metal surfaces having minor blemishes with fine crocus cloth.
3.
Coat all parts with clean hydraulic oil.
END OF TASK
INSTALLATION
1.
Install two grease fittings (Figure 3, Item 1) into barrel assembly (Figure 3, Item 2).
1
2
1
M2310105
Figure 3.
Axle Lockout Cylinder Installation.
03/15/2011Rel(1.8)root(maintwp)wpno(M00168)
