TM 5-3810-305-23
0152
INSTALLATION - Continued
2.
Install two new o-rings (Figure 4, Item 1) and two elbows (Figure 4, Item 10) on cylinder (Figure 4, Item 7).
3.
Set cylinder (Figure 4, Item 7) into position onto carrier (Figure 4, Item 8).
4.
Align cylinder (Figure 4, Item 7) bottom mounting holes with carrier (Figure 4, Item 8). Install one of two washers
(Figure 4, Item 3), pin (Figure 4, Item 4), and remaining washer. Secure pin with washer (Figure 4, Item 5) and
capscrew (Figure 4, Item 6).
5.
Align remaining cylinder (Figure 4, Item 7) mounting hole with carrier. Install one washer (Figure 4, Item 3),
pin (Figure 4, Item 4), and remaining washer. Secure with washer and capscrew (Figure 4, Item 6).
6.
Connect hydraulic hoses (Figure 4, Item 9).
7.
Close dipstick cap and start engine. Slightly open bleeder screw (Figure 4, Item 2) to bleed air from axle lockout
cylinders. Check for leaks.
2
1
3
4
56
7
10
9
3
8
5
6
4
M0321105
Figure 4. Axle Lockout Cylinder Installation.
03/15/2011Rel(1.8)root(maintwp)wpno(M00168)