TM 5-3810-305-23
0153
REMOVAL - Continued
9.
Remove eight locknuts (Figure 4, Item 1), washers (Figure 4, Item 2), plug (Figure 4, Item 3), o-ring
(Figure 4, Item 4), cover (Figure 4, Item 5), o-ring (Figure 4, Item 6), filter (Figure 4, Item 7), and o-ring
(Figure 4, Item 8) from reservoir (Figure 4, Item 1). Discard o-rings.
3,4
5
1,2
7,8
6
M0339105
Figure 4. Hydraulic Reservoir Removal.
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use
assistance during procedure. Ensure any lifting device used is in good condition and of
suitable load capacity. Keep clear of heavy parts supported only by lifting device. Failure to
follow this warning may result in injury or death to personnel.
NOTE
Weight of hydraulic reservoir is approximately 190 lb (86 kg).
10.
Using suitable hoist and sling, lift hydraulic reservoir (Figure 5, Item 4) from vehicle and place on a
suitable surface.
END OF TASK
CLEANING
Clean parts IAW General Maintenance Instructions (WP 0162).
END OF TASK
03/15/2011Rel(1.8)root(maintwp)wpno(M00169)