TM 5-3810-305-23
0156
REMOVAL - Continued
7.
Turn ignition switch ON. Bleed pressure from boom extend cylinder by operating boom telescope lever.
8.
Disconnect two hydraulic hoses (Figure 2, Item 1) from boom extend cylinder.
1
M0617105
Figure 2.
Boom Assembly Removal.
9.
Close dipstick cap. Start engine. Elevate boom to 10 degrees to allow for placement of suitable bracing material
under boom hoist cylinder.
WARNING
Weight of boom hoist cylinder is approximately 507 lb (230 kg). Use adequate lifting
equipment to lift and support boom hoist cylinder. DO NOT lift over personnel or let
personnel walk underneath suspended load. Failure to follow this warning may cause
injury or death to personnel.
03/15/2011Rel(1.8)root(maintwp)wpno(M00172)