TM 5-3810-305-23
FIELD MAINTENANCE
GENERAL WIRING HARNESS AND CABLE MAINTENANCE
INITIAL SETUP:
References
TB SIG 222
This work package contains instruction on repair of wiring harnesses and cables (leads). Repair of wiring harnesses
and cables consists of replacement of defective connectors, shells, and terminals, or taping cut or worn insulation
and exposed wire conductors. Exploded views of typical harness and cable connectors used on the vehicle and
given procedures for disassembly and assembly of connecters. When soldering is required, procedures in TB SIG
222 must be followed. If multiple pin connectors are disassembled, tag or label all wires and cables to ensure that
correct connections are made at time of assembly. The following procedures are contained in this work package:
Typical Panel Mounting Receptacle: Disassembly and Assembly
Typical Plug Disassembly and Assembly
Terminal-type Cable Connectors Replacement
Male Cable Connector Replacement
Female Cable Connector (with Washer) Replacement
Female Cable Connector Electrical Harness Identification
Female-Type Panel Mounting Receptacle Disassembly and Assembly
Male-Type Panel Mounting Receptacle Disassembly and Assembly
Female-Type Panel Mounting Receptacle with Ridged Locking Nut Disassembly and Assembly
Male-Type Panel Mounting Receptacle with Ridged Locking Nut Disassembly and Assembly
Female-Type Plug with Ridged Locking Nut
Male-Type Plug with Ridged Locking Nut
Cable Connectors
0163-1
03/15/2011Rel(1.8)root(maintwp)wpno(M00186)