TM 5-3810-306-20
6.
REMOVE
FUEL
SUPPLY
PRESSURE
TRANSDUCER (10), FUEL SUPPLY TUBE (8) AND
FITTINGS FROM FUEL PUMP (6). RETAIN FOR
INSTALLATION.
7.
INSPECT PARTS FOR DAMAGE. REPLACE AS
REQUIRED.
INSTALLATION:
1.
INSTALL FUEL SUPPLY TUBE (8), FITTINGS AND
FUEL SUPPLY PRESSURE TRANSDUCER (10) TO
FUEL PUMP (6).
2.
INSTALL FUEL PUMP (6).
a. Clean fuel pump mounting surface until free of
gasket material.
b. With new gasket (12), mount fuel pump (6) with
two capscrews (11).
3.
INSTALL FUEL SUPPLY TUBES.
a. Attach fuel supply line (7) to fuel pump (6).
b. Using two new washers (5) attach fuel supply
tube (8) to engine block with connector screw
(4).
c. Install fuel manifold line (3) with new seal (2) and
secure with connector screw (1).
4.
CONNECT FUEL LINE (13).
5.
CONNECT ELECTRICAL CONNECTOR (9) TO
FUEL SUPPLY PRESSURE TRANSDUCER (10).
6.
CONNECT GROUND CABLE AT SHUNT. (REFER
TO PAGE 8-109.)
7.
START ENGINE. (REFER TO TM 5-3810-306-10.)
CHECK FOR FUEL LEAKS.
END OF TASK
5-19
